产品说明：
LDT0压电薄膜传感器:The ‘L’ in LDT Series stands for ‘laminated’ sensor. Typically, a 0.005” (125μm) polyester layer is laminated to a 28 μm or 52μm piezo film element. When used in a ‘bending’ mode, laminated film elements develop much higher voltage output when flexed than a non-laminated DT elements series. The neutral axis is in the laminate instead of in the film so the film is strained more when flexed. The capacitance is proportional to the area and inversely proportional to the thickness of the element. Piezo film sensors LDT elements are available in a variety of lead attachment options. For significantly increased sensitivity, the LDTM-028K (M-Mass) combines an LDT0-028K form factor with the addition of a 0.72 gram round mass. The LDT1, 2 and 4 have 12” of 26 gauge twisted pair wire. The LDT0-028K and LDTM-028K with solder tabs can be soldered directly to a PCB with areasonable level of care. Piezo film cannot withstand high temperatures (>80°C),andthereforesoldering of the pins to a PCB must be done quickly. A heatsink clamped to the interface area between the film and the crimps will take the heat away from the film. Pre-tin thePCBandthenquickly solder the sensor to the board. Do not allow the soldering iron to touch the film, and do not use a dwell time of over 5 seconds on the pins. Low temperature solders can also be used. For tightly tolerance sensitivity requirements, please consult MeasurementSpecialties for techniques used to control variations of boundary conditions in production.
所属品牌： MEAS
输出： 高电压输出
量程： -
封装：薄膜元件
工作温度范围： 0～70℃
精确度：1.4V/g~16V/g
供电电源：无源
特点：宽频（0.001Hz～1000MHz），高灵敏度，高介电强度，低声阻抗，高稳定性
类型：压电薄膜悬臂梁质量块
电气连接： PC板安装
典型应用： 汽车防盗报警器,卧式滚筒洗衣机振动，电子靶，计数器触发器 ，生命特征的监护
资料下载：http://www.sensorway.cn/sensors/118.html