CPU
    AMD Geode™ LX800,500 MHz on Board
    128 KB L2 cache (64 KB I-cache/64 KB D-cache)
内存    1 x 200-pin SO-DIMM socket, up to 1GB Non-ECC/Non-Registered DDR SDRAM (64-bit, 200 MHz)

芯片组    AMD Geode LX800 / AMD CS 5536

BIOS
    Award system BIOS
    Plug & Play support
    Advanced Power Management and Advanced Configuration & Power 界面
    4M bits flash ROM ACPI
    ACPI support: Only support Software Shutdown by 5Vsb Provided

网络
    1 x Realtek 8139C+ 10/100 Fast Ethernet Controller
    Supports Boot From LAN (PXE)
    Supports Wake on LAN
    1 x RJ45 with LED

显示
    The Geode™ LX800 integrated Graphic, supports both standard VGA and TFT
    CRT Supports up to 1920x1440x32 bpp at 85 Hz
    1 x DB15 VGA Connector
    TTL LCD supports up to 24bit, 1600x1200x32 bpp at 60 Hz for TFT

音频
   REALTEK,ALC203 CODEC for AC97 v. 2.0
    Mic in and Speaker out connector, Line in with pin header
I/O 接口    4 x USB 2.0 port (USB 1/2 on front, USB 3/4 via one JST connector), bandwidth: 480 Mb/s
    2 x SIO, 16C550 UARTs (One on front support RS-232, one onboard with 10-pin header support RS-422/485)
    Parallel ports:Bi-directional, EPP/ECP support, 1 x Box header 26-pin connector
    PS/2: 1 x 6-pin Box Header
    FAN: 1 x FAN JST connector (for CPU)
    IrDA: 1 x 5-pin Box Header for IrDA,TX,RX
    1 x On Board buzzer
1 x 3 pin header for SM Bus, one pin for GND
1 x 2 pin header for Reset switch
1 x 2 pin header Power LED
1 x 3 pin header for I2C BUS, one pin for GND

存储
    CF: 1x Internal CompactFlash 插槽
    支持1个Type I& II Compact Flash Card (Primary Master)
    IDE: 1 x 44-pin IDE connector,support Ultra DMA 33/66/100
1 x 2-pin IDE Active LED Header

看门狗    可软件编程看门狗:0 ~ 255 seconds 和0 ~255 minutes (室温25度下公差15% )

板载RTC
    板载RTC 带电池备份
    1 x External Li-ion Battery

电源
    Supports both AT and ATX Mode (BIOS and H/W is default to AT mode)
    AT Mode: +5V Power in,No Power On push Button, Software Shutdown function and LAN remote wake up
    ATX Mode: Power Required: +5V / -5V / 5Vsb Power In
When Change to ATX Mode, the BIOS default setting is as follow:
POWER -SUPPLY TYPE -->[ATX>
AUTO PWR-FAILURE RESUME-->[ON>

尺寸    3.5” 146 mm (L) x 105 mm (W) 

环境
    操作温度:0°C to 60°C
    存储温度:-20°C to 85°C
    相对湿度: 10% to 90% (无凝露)

认证
    CE approval
    FCC Class A